Partially transparent spray (green)
Partially transparent spray (green)
Partially transparent spray (green) is used during working with clean materials such as glass and acrylic, where the image must be transferred to the back of the material, allowing the light to pass through them. This spray is used after a previously applied pure sublimation coating. The image is placed over white color so that when viewed from the good side, the image has a white background.
How to use partially transparent spray green:
-
Shake well spray for 1 minute
-
Check the substrate on which you will apply the spray, as it should be clean, dry and not greasy
-
Apply adhesion material to the surface of the material
-
Pre-coat with pure sublimation coating and allow it to dry for about 5 minutes
-
Then apply a thin layer of partially transparent spray and leave to dry for about 5 minutes
-
Seal at 160 oC for 15-20 minutes
Use it as:
-
As the background through which the picture will be transmitted
-
To miss the light through the material for image illumination
*NOTE
This spray is used exclusively for glass products, if you want the glass surface to take on a white background. The effect is incredible because after applying this spray the image no longer has a transparent effect, but the colors are much more permanent and stronger because they are applied to the white background.
